Authorization Of Users; Authorization With Two Identifiers; Factory Default Codes - Satel INTEGRA Plus User Manual

4

4. Authorization of users

Operation of the alarm system is possible after the user authorization, which allows the
control panel to verify that the user is authorized to perform the given operation. The
authorization can be done on the basis of:
 code,
 proximity card (125 kHz passive transponder, which can be in the form of card, tag, etc.),
 DALLAS iButton (chip),
 keyfob.
You can not assign the same identifier (code, proximity card, DALLAS iButton or
keyfob) to two users.
For safety reasons, different people should not use the same identifier.
The installer can configure the panel so that it will not accept codes that contain less
than three digits (e.g. 1111 or 1212) or consist of consecutive digits (3456).
The installer may permit the use of certain functions without the need for user
authorization.
Using an invalid code, proximity card or DALLAS iButton three times may:
 trigger an alarm;
 block the keypad / reader for 90 seconds.
4.1

Authorization with two identifiers

The INT-KLCDR keypads and the INT-SCR multifunction keypads have a built-in proximity
card reader. The installer can configure these devices so that the user has to use two
identifiers for authorization: the code and the card. The function to be executed after the
authorization depends on the second identifier:
– code – whether it will be confirmed by using the
– card – whether it will be presented only or held.
4.2

Factory default codes

By default, the following codes are preprogrammed in the control panel:
Service code: 12345
master (administrator) code for partition 1: 1111
The factory default codes make it possible to assign individual codes to consecutive persons
who are to use the alarm system (see: section U
The factory default codes should be changed as soon as possible using the C
function available in the user menu.
OWN CODE
The control panel can inform the user that the code change is necessary, if the code is
known to other users.
The master code should not be used on a daily basis because of the risk of its being
captured. It is recommended that the administrator enter for himself an ordinary user's
code.
User Manual
key or the
p. 23).
SERS
SATEL
key ;
HANGE