OPTEX FA FASTUS CDX-L15A User Manual page 51

2-9-3 Quota
This is the number of data entries to save until the storage function is stopped when the storage function is in
use.
• Input range: 1 to 100,000
• Default value: 1000
2-9-4 Rate
Sets the interval during which data should be saved for all measured data.
Not all measurement data is saved. Saving is done intermittently to reduce the amount of data stored and to
facilitate processing.
• "0":
• Number (positive values only): For each data entry stored, a single measurement value is saved for
• Input range:
• Default value:
Ex.: For example, if 5 is specified as the intermittent setting, the following operation will be performed.
* ●: Data for which both measuring and saving are performed.
○: Data for which measuring is performed but saving is not.
2-9-5 Start condition
Sets the "Start trigger" conditions used as the basis for starting storage.
• Immediate:
• Alarm Off edge:
• Alarm On edge:
• Threshold Up edge:
• Threshold Down edge: Storage starts when the measured value falls below the set threshold.
• Threshold Both edge:
• Default value:
2-9-6 Threshold
When "Start condition" is "Threshold Up edge," "Threshold Down edge," or "Threshold Both edge," this
setting specifies the threshold to be used as the reference for the start condition.
• Input range: ±2000.000000 (mm)
• Default value: 0
All obtained data is stored.
each specified sampling.
0 to 1,000,000
10
Storage starts immediately.
Storage starts from the instant measurement becomes possible.
Storage starts from the instant measurement becomes impossible.
Storage starts when the measured value exceeds the set threshold.
Storage starts when the measured value exceeds or falls below the set threshold.
Immediate
Storage Screen
2-31
1
2