Sensor Head Instruction Manual Displacement Sensor CD5 Series Laser Type (CD5-L_25,CD5-_30,CD5-_85,CD5-W350,CD5-W500,CD5-W2000) Table of Contents page SAFETY PRECAUTIONS ..... 3 Specifi cations ........8 BASIC INFORMATION BEFORE USE ..10 Sensor Head Installation ..12 R e a d t h i s I n s t r u c t i o n M a n u a l before use for the safe and correct operation.
Page 2
FOREWORD Thank you for purchasing the Displacement Sensor CD5 Series. We hope you are fully satisfied with this product and enjoy its performance. To ensure your satisfaction, please follow the instructions below. Carefully read this instruction manual and keep it for future reference.
SAFETY PRECAUTIONS Carefully read and understand the safety precautions before operation. They provide the important information to protect your health and property. Strictly follow this instruction manual, and do not apply any other installing/operating procedure which is not described in this manual. Meanings of Safety Symbols Indicates a possible hazard that may result in death or serious injury if the product is used without observing the stated...
Page 4
Mandatory Requirements This product cannot be used as a safety device to protect human body. Do not stare into laser beam or point laser beam at eyes since it may damage the eyesight. Do not disassemble or modify the product since it is not designed automatically to stop the laser emission when it is opened.
Page 5
Precautions for Installation Do not install or use the product at the following places. It may lower accuracy or cause a failure. A place where; The operating temperature or humidity exceeds the specified value; The receiving part is directly exposed to sunlight or ambient light. (Use a tool like a sun visor for improved accuracy);...
Page 6
Cautions for Laser Product This sensor emits visible laser beam compliant with JIS C6802/IEC/FDA, laser safety standard Class 1, 2 ( ) or 3R ( The warning and description labels are stuck on the side of the product. Laser type of this product Type Red Laser Diode Wavelength...
Page 7
Label of each model CD5-30 / CD5-W30 CD5-L25 / CD5-LW25 CD5-85 / CD5-W85 CD5-W350 CD5-W500 CD5 Sensor Head...
BASIC INFORMATION BEFORE USE Parts Identifications of Sensor Head φ Package Descriptions Sensor Head Main Unit Screw(3 pcs.) Instruction Manual (This document) Laser Label to stick on the device Displacement sensor...
Page 11
It is possible to use the CD5 sensor head without the special controller by connecting the CD5 sensor head directly to the device. The figure below shows how to connect the cable. Contact OPTEX FA for communicative specifications (RS422) or wiring. × ...
Sensor Head Installation Avoid the position of operator’s eye height for sensor head installation. Turn off the controller before connecting/disconnecting the sensor head to/from the controller. Do not drop or apply a shock to the product. It may damage the product or lower the accuracy.
Page 13
Object of two or more materials or colors Rotating object To measure hole or concave CD5 Sensor Head...
Page 14
To fix the sensor head on the wall The detection surface (the side of the emitting/receiving parts) should be parallel to the target object. Adjust the spot to conform to the detection point. Ensure that the distance indicator turns orange when the detection point (the center of displacement) passes the spot point.
Page 15
Sensor head Installation Follow the instructions below when handling a cable or an extension cable. An excess stress may cause cable breakage. Do not pull the cable with the power of 29.4 N and more. Do not bend the cable with its radius less than 30 mm.
Page 16
Connecting Connectors for Sensor Head Ensure the cutout of connector smoothly fits the protruded part of controller. Forced connector insertion can damage the connector pin seriously, causing bend or other problems. Insert the connector cutout to the protruded part of controller. Turn the connector lock to the direction of arrow mark (clockwise direction) until it clicks.