Timing Recap - Malibu Boats Wakesetter 20VTX 2019 Owner's Manual

Timing Recap

The timing recap will
display the buoy times for
the last two course runs.
Touch Exit to return to
the Home screen.
Slalom Wait Time
Wait Time is the amount of time a skier
can wait in the water before the warning
timer starts to beep, indicating it is time
to pull up the skier. As the warning timer
nears the end, a beeper start to indicate the
amount of warning time is close to the end. The beeping continues
to increase in speed and volume in relation to the amount of warning
time remaining. Each press of the up or down arrow increases or
decreases the time by five seconds.
Jump Settings
Select Jump, then touch
the symbol in the upper left
corner of the screen, and the
following will appear:
Buzzer Volume
The buzzer volume
adjustment compensates for
increased engine noise. As
the boat speed increases, and
therefore the noises from the
engine increase, the volume
of the buzzer will increase
proportionately to the boat's speed between 0 and 25 mph (40.2
km/h). No further increase occurs at speeds above 25 mph (40.2
km/h). The buzzer emits a sound when the set speed is reached and
when reaching the buoys at a course. Select Buzzer Volume, and the
following appears:
Select the volume for High and Low speed by utilizing the up and
down arrows. Touch Back to return to the Slalom Settings screen.
2019 Malibu Boats, LLC Owner's Manual • Page 86
https://www.boat-manuals.com/
Timing Recap
The timing recap will
display the buoy times for the
last two course runs.
Touch Exit to return to the
Home screen.
Jump Switch
This number either
increases or decreases the
intensity of the "bump" value
upon jump switch engagement.
The number on the
left side of the colon
is for the first segment
in the jump and the
number on the right
side of the colon is for
the second segment
of the jump. Depending on the boat, it can help jumpers achieve a
balanced time.
Touch each number to view and select an alternative number.
Your authorized Malibu dealer can help you determine the
strength number that is best for your boat.
Jump Switch Timeout
This is the amount of time
that the boat will apply the
accelerator on the jumpers
counter cut (or anytime the
jumper is out of the actual
jump course).
This setting is adjustable
for extreme headwinds or tailwinds, but it is recommended that it be
left at 1.8 in nearly all instances.
Touch Back to return to the Jump Settings screen.
Trick Settings
Select Trick, then touch the symbol in the upper left corner of
the screen. The following will
appear: