Table of Contents
Advertisement
•
Release the coupler latch. The hitch pin should fit easily into the
hole. If it does not, this means that the latch is not completely
closed. It will not close unless the coupler fits snugly over a
properly sized ball. If the hitch pin is damaged or lost, it must be
replaced prior to operating the rig.
you can operate temporarily with a one-quarter inch
(1/4") or five-sixteenths inch (5/16") shank padlock.
Never operate without the hitch pin or padlock as the
trailer and contents can become disengaged from the tow
vehicle, which may result in serious injury or death.
To Open the Coupler
•
Remove the hitch pin from the hole in the side of the coupler.
•
On the standard Malibu trailer, push the button on the side.
(Other trailers do not have the button.)
•
While holding the button, raise the handle.
To Close the Coupler
•
Place the coupler over the ball.
•
Lower the coupler.
•
Close the handle. An audible sound will be heard. If the handle
does not close easily, the ball is not fully within the socket. DO
2019 Malibu Boats, LLC Owner's Manual • Page 148
Never move the trailer
toward the tow vehicle.
When the trailer is not fully
hitched up, the brakes are
not operational.
The hitch pin must be
properly installed and
secure prior to operation.
If it is damaged or missing,
https://www.boat-manuals.com/
NOT FORCE the handle to close as it is likely that the ball is the
wrong size and should be replaced.
back through the steps to ensure that it will close and
stay closed. If you are unable to get the system to perform
correctly, see an authorized Malibu Trailer dealer for
assistance. Failure to get the coupler secure could result
in the trailer disengaging, which could lead to serious
injury or even death.
Hitching Up
•
The coupler should easily unlatch, but if it does not, check to
see if the ball is correctly sized, or if the trailer is parked on a hill,
which will inhibit the ability to successfully open the coupler.
•
After securing the coupler to the hitch ball, double-check that the
hitch pin is properly installed and the coupler handle secure.
•
Cross the safety cables under the coupling, allowing only enough
slack to enable turning when the rig is in operation.
•
Attach the breakaway cable under the coupling.
•
Connect the trailer's seven-wire connector to the seven-wire
connector of the tow vehicle and check that the lights are working
correctly. (More information on the Lights follows in the Trailer
Components and How They Function section of this Owner's
Manual.)
CONNECTING
TO THE BOAT
Trailer Winch
The trailer winch is a manually operated device to assist loading
the boat onto the trailer and maintaining it in position for proper
towing. The following information is important in assuring control and
protection for you and the boat:
NEVER tow with the
coupler handle open or
partially open. If the handle
will not remain closed, go
Advertisement
Table of Contents
