Txi Standard Gauges And Screen; Gauges; Keypad; Center Screen - Malibu Boats Wakesetter 20VTX 2019 Owner's Manual

TXi
Standard Gauges
and Screen
Functionality is explained in this section. Additional information
about certain aspects of the controls is also discussed in further
detail in other sections of the Owner's Manual. Be sure to read the
entire manual before attempting to operate the controls.

Gauges

The instrument panel features two (2) five-inch (5") gauges,
which provide real-time information about important drive train
functions.
is the engine temperature reading. If the temperature sensor notes
a reading above the programmed, acceptable level an alarm will
sound. More information about alarms follows in this section of the
Owner's Manual.
The lower right of the gauge is the engine oil pressure reading.
If the oil pressure sensor notes a reading above the programmed,
acceptable level an alarm will sound. More information about alarms
follows in this section of the Owner's Manual.
The right side gauge
is the tachometer/
voltage/fuel level display.
The tachometer,
which is the upper half
of the gauge, shows
the engine revolutions
per minute (rpm)
numerically-times-1,000.
The lower left portion
of the gauge shows the electrical voltage at the alternator output.
The desired range during engine operation is above 13.5 volts. See
the battery information that follows in this section of the Owner's
Manual for additional details regarding the proper charging and
2019 Malibu Boats, LLC Owner's Manual • Page 75
The top of the left gauge
is the speedometer, which
shows the boat's speed
as determined by the
paddlewheel under the hull.
The speed reads in miles per
hour (mph).
The lower left of the gauge
https://www.boat-manuals.com/
battery switch designation.
The lower right side of the gauge shows the approximate level of
the fuel in the fuel tank. Note that movement of the boat can affect
the reading, especially as fuel levels lower. Be certain to read the
Fueling information in the Get Ready section of this Owner's Manual
before operating the boat for important information.

Keypad

Center Screen

Located between the two
gauges is an LCD screen that
provides information on much
of the boat's functionality. The
following information provides
detail.

Cruise Screen

Cruise Mode
Shows the current status of CRUISE MODE. When turned ON
and ENGAGED, the cruise control system will automatically control
the speed of the boat after the ACTUAL SPEED has reached the
desired SET SPEED.
CRUISE MODE is activated.
More throttle is needed to reach SET SPEED.
SET SPEED has been achieved and the boat can now
automatically maintain consistent speed.
A keypad is
provided to assist
in maneuvering
among the functions
controlled from this
location. Additional
information follows.