Governor 8Ch 43P; Free Mix (Aircraft And Helicopter) - GRAUPNER HOT TG/mz-12 Operating Instruction

- Governor 8ch
Press the direction button to select the governor 8ch then press the ENT button to access
the function. The value no of is highlighted. You may select yes or no by the direction
button. Press the ESC button to remove the highlight.
press
- Governor rate
Press the direction button to select the governor rate then press the ENT button to access
the function. The value 0% of is highlighted. Press the direction button to adjust the de -
sired value then press the ESC button to remove the highlight.
ENT
TEL VIW
ESC
press
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
9. free mixer (Aircraft and Helicopter)
The free mixer allows to select the master channel that is controlling channel and the salve channel.
ENT
The Master channel will be mixed to the slave channel and the slave channel will follow the master
TEL VIW
channels input based on the rate that is programmed. Three free mixers are available for each of
ESC
the ten model memories.
- Free mixer
press
Press the ENT button to access the free mixer. The first ?? at M1 line is highlighted then press the
ENT button to highlight the value. The first ?? is for the master channel programming. Press the
direction button to select the master channel then press the ESC button to remove the highlight.
ENT
Press the direction and ENT buttons to select the next M1 ?? and highlight the value. The next ?? is
TEL VIW
for the slave channel programming. Press the direction button to select the slave channel then press
ESC
the ESC button to remove the highlight. Press the direction button to select the hyphen then press
the ENT button then the popup message "push desired switch into position on" appears. Move the
switch then the corresponding value appears (The M1 free mixer is on/off when the switch is moved).
Press the direction button to select the arrow mark then press the ENT button to access the free
mixer ratio. The SYM is highlighted then press the ENT button to highlight both values of the trv line.
Press the direction button to adjust the desired value. Both values are adjusted simultaneously and
appeared in the diagram.
press
press
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
press
ENT
TEL VIW
ESC
43