Figure 150 Rear View Of A Controller Enclosure (Eternus Dx500 S5) - Fujitsu ETERNUS DX S5 Series Design Manual

6. Hardware Configurations
Controller Enclosure
●
Rear View
ETERNUS DX500 S5
•
Figure 150
CPSU#0
8
1
Controller (CM#0, CM#1)
(Refer to
2
Host interface (CA#0, CA#1)
(Refer to
3
RMT (LAN) port
This port is used for connecting a LAN cable. Use this port to separate the network (such as for the
remote support) from the MNT port for operation management. This port uses an RJ-45 connector.
(Refer to
4
MNT (LAN) port
This port is used for connecting a LAN cable and used for operation management. This port uses an
RJ-45 connector.
(Refer to
5
FST (LAN) port
A port that is dedicated for maintenance engineers. Customers must not use this port.
(Refer to
6
Drive interface (OUT) port
This port is used to connect a controller enclosure to a drive enclosure with a mini SAS HD cable
between enclosures.
(Refer to
7
PWC port
This port is used to connect a power synchronized unit with an RS232C cable.
(Refer to
8
Power supply unit (CPSU#0, CPSU#1)
(Refer to
9
BUD (BUD#0, BUD#1)
(Refer to
Rear View of a Controller Enclosure (ETERNUS DX500 S5)
1 1 2
CM#1
CA#0
CM#0
CA#0
9 9
"Controllers" (page 257).)
"■ Host Interfaces" (page
"■ MNT Ports/RMT Ports/FST Ports" (page
"■ MNT Ports/RMT Ports/FST Ports" (page
"■ MNT Ports/RMT Ports/FST Ports" (page
"■ Drive Interface Ports" (page
"■ PWC Ports" (page 263).)
"■ Power Supply Units" (page
"■ BUD" (page 258).)
2
CA#1
CA#1
3 4 5 6 7
259).)
263).)
263).)
263).)
263).)
264).)
253
CPSU#1
8
Design Guide