Remote Connections; Remote Interfaces; Figure 111 Example Of Non-Supported Connection Configuration (When Multiple Types Of Remote Interfaces Are Installed In The Same Eternus Af/Dx); Figure 112 Example Of Supported Connection Configuration (When Multiple Types Of Remote Interfaces Are Installed In The Same Eternus Af/Dx) - Fujitsu ETERNUS DX S5 Series Design Manual

5. Connection Configuration

Remote Connections

Remote Connections
An FC or iSCSI interface is available for a remote connection.
When a remote connection is used, change the host interface port mode setting from "CA" to "RA".
Caution
When different types of remote interfaces exist in the same ETERNUS AF/DX, make sure to use the same
type of interface for each REC path. For example, the following configuration is not supported because
different types of interfaces (FC and iSCSI) exist together on an REC path.
Figure 111
Interfaces Are Installed in the Same ETERNUS AF/DX)
ETERNUS AF/DX
FC-RA
iSCSI-RA
The following configuration is supported because the same type of interface is used for each REC path.
Figure 112
Are Installed in the Same ETERNUS AF/DX)
ETERNUS AF/DX
FC-RA
FC-RA

Remote Interfaces

Change the port mode of the host interface ports to use them as remote interfaces. For details on changing the
port mode, refer to "ETERNUS Web GUI User's Guide".
This section describes each remote interface.
Example of Non-Supported Connection Configuration (When Multiple Types of Remote
ETERNUS AF/DX
FC-RA
REC path
iSCSI-RA
Example of Supported Connection Configuration (When Multiple Types of Remote Interfaces
ETERNUS AF/DX
FC-RA
REC path
FC-RA
ETERNUS AF/DX
iSCSI -RA iSCSI -RA
REC path
iSCSI -RA iSCSI -RA
216 Design Guide