Figure 143 Rear View Of A Controller Enclosure (When The Eternus Dx60 S5 Is Installed With Two Controllers) - Fujitsu ETERNUS DX S5 Series Design Manual

6. Hardware Configurations
Controller Enclosure
Figure 143
Controllers)
1
2 3
1
Controller (CM#0, CM#1)
(Refer to
2
PWC port
This port is used to connect a power synchronized unit with an RS232C cable.
(Refer to
3
Host interface
This interface is used for connecting a controller with a server.
(Refer to
4
Drive interface (OUT) port
This port is used to connect a controller enclosure to a drive enclosure with a mini SAS HD cable
between enclosures.
(Refer to
5
RMT (LAN) port
This port is used for connecting a LAN cable. Use this port to separate the network (such as for the
remote support) from the MNT port for operation management. This port uses an RJ-45 connector.
(Refer to
6
MNT (LAN) port
This port is used for connecting a LAN cable and used for operation management. This port uses an
RJ-45 connector.
(Refer to
7
Power supply unit (PSU#0, PSU#1)
(Refer to
Rear View of a Controller Enclosure (When the ETERNUS DX60 S5 Is Installed with Two
4 5 6
CM#0
PSU#0
7
"Controllers" (page 257).)
"■ PWC Ports" (page 263).)
"■ Host Interfaces" (page 259).)
"■ Drive Interface Ports" (page
"■ MNT Ports/RMT Ports/FST Ports" (page
"■ MNT Ports/RMT Ports/FST Ports" (page
"■ Power Supply Units" (page
1
2 3 4 5
CM#1
PSU#1
7
263).)
263).)
263).)
264).)
248
6
Design Guide