Figure 3-4 Ethernet Cable Assembly; Connecting The Power Cord - H3C SecPath V100-S Installation Manual

Installation Manual
H3C SecPath V100-S Security Gateway
II. Ethernet cable
The SecPath V100-S uses category-5 twisted-pair cables to match its Ethernet
interfaces (the cables can be either straight-through cables or and crossover cables
since the interfaces are MDI/MDIX auto-sensing), as shown in Figure 3-4.

Figure 3-4 Ethernet cable assembly

Note:
When preparing network cables, it is recommended to use shielded cables for the sake
of electromagnetic compatibility.
III. Connecting the Ethernet cable
Take the LAN0 interface on the front panel of the SecPath V100-S for example. Follow
these steps to connect its Ethernet cable:
Caution:
Read the mark above the interface carefully to avoid misconnection.
Step 1: Connect one end of the Ethernet cable to the security gateway and the other
end to the peer device.
Step 2: Check that the LINK/ACT LED corresponding to LAN0 is on. ON means a link is
present on the interface. OFF means no link is present on the interface and you should
check the connection.

3.6 Connecting the Power Cord

The SecPath V100-S has AC-powered model.
I. AC power supply
AC input: 100 VAC to 240 VAC, 50 Hz or 60 Hz
Chapter 3 Installing the SecPath V100-S
3-5