Table of Contents
Advertisement
Installation Manual
H3C SecPath V100-S Security Gateway
2.1.5 Lightning Protection
By design, the SecPath V100-S is lightning protective; but excessive lightning may still
damage the device. To protect the device better, you are recommended to:
Ensure the PGND of the chassis is securely connected to the earth ground.
Ensure the earth point of the power socket is securely connected to the earth
ground.
Add a lightning arrester onto the front end of the power input to better protect the
power supply from lightning strikes.
2.1.6 Checking the Rack
When installing the SecPath V100-S, observe the following:
Reserve adequate clearance at the air intake exhausting vents for adequate
ventilation inside the chassis.
Make sure that the rack has a good ventilation system.
Make sure that the rack is stable enough to support the weight of the device and
the installation accessories.
Make sure that the rack is well-grounded.
2.2 Safety Precautions
When reading this manual, pay adequate attention to the following.
Warning appears in operation procedures that, if performed incorrectly, might
cause bodily injury to the operators or damage the device.
Caution appears throughout this manual in procedures that, if performed
incorrectly, might affect the operation of the device.
When installing or working on the SecPath V100-S, you are recommended to:
Keep the SecPath V100-S far away from the heat sources and water/liquid.
Make sure that the SecPath V100-S has been correctly grounded.
Wear an ESD-preventive wrist strap in installation and maintenance, making sure
that the strap has good skin contact.
Do not hot swap the console cable or AUX cable.
Adopt uninterrupted power supply (UPS).
2.3 Unpacking Check
Check the arrived shipment contents against the packing list, making sure all the items
are included and in good condition. Contact your agent for shortage or wrong delivery.
Chapter 2 Installation Preparations
2-3
Advertisement
Table of Contents
