Table 1-5 Attributes Of The Ethernet Interfaces - H3C SecPath V100-S Installation Manual

Installation Manual
H3C SecPath V100-S Security Gateway
III. Ethernet interface
The SecPath V100-S provides five 10/100 Mbps auto-sensing FE interfaces. The
following table lists their attributes.

Table 1-5 Attributes of the Ethernet interfaces

Connector
Interface standard
Frame format
Operating mode
Note:
Media-dependent interface (MDI) is often used on general network adapters;
media-dependent interface cross-over (MDIX), is usually used on Hubs or LAN
switches.
Attribute
RJ45
All Ethernet interfaces on the SecPath V100-S support
MDI/MDIX autosensing.
Ethernet_II
Ethernet_SNAP
10/100 Mbps auto-sensing
Full-duplex/Half-duplex
Description
1-6
Chapter 1 Product Introduction