H3C SecPath V100-S Installation Manual page 30

Installation Manual
H3C SecPath V100-S Security Gateway
Note:
The contents displayed on the terminal may vary for different Boot ROM versions.
************************************************
*
* H3C SecPath Series Gateway Boot ROM V1.00
*
************************************************
Copyright(C) 2004-2007 by Hangzhou H3C Technologies CO., LTD.
Compiled at Wed Apr 12 17:39:36 CST 2006..
Testing memory...OK!
128M
8192K bytes
Hardware Version is MTR 1.0
CPLD Version is CPLD 0.0
Press Ctrl-B to enter Boot Menu
Press <Ctrl+B> now to enter the Boot Menu. Otherwise, the system starts
decompressing the program.
Note:
To enter the Boot Menu, you must press <Ctrl+B> within three seconds after the
prompt "Press Ctrl-B to Enter Boot Menu..." appears.
The system starts decompression and initialization, and displays:
System is starting...
Number 1 memory block start from address 0x23000000 ,length 0xd000000
User interface Con 0 is available.
Press ENTER to get started
Press <Enter>, and the system displays (if login authentication is not enabled):
<H3C>
bytes DDR SDRAM
flash memory
Chapter 4 Booting and Configuring the SecPath V100-S
*
*
*
4-5