H3C SecPath V100-S Installation Manual page 37

Installation Manual
H3C SecPath V100-S Security Gateway
Please wait, it may take a long time
########################################################
Writing FLASH Success.
Please use 9600 bps.Press <ENTER> key to reboot the system.
Restore the speed of the console terminal to 9600 bps as prompted, and then
disconnect and reconnect the terminal. The system starts up normally.
II. Upgrading the entire Boot ROM program
Step 1: Enter the Boot Menu (see section 5.1 "Boot Menu"), and select <7> to enter the
Boot ROM operation menu.
Step 2: Select <1> in the Boot ROM operation menu to download the Boot ROM
program using XModem. The security gateway provides several speed options. The
subsequent operation steps are the same as those described in section 5.2
"Upgrading the application program".
Caution:
If you fail to upgrade the entire Boot ROM program, you cannot restore it on site.
Therefore, you can only upgrade the entire Boot ROM program under the direction of
technical support engineers and when it is urgently necessary.
III. Upgrading the extended segment of the Boot ROM program
Step 1: Enter the Boot Menu (see section 5.1 "Boot Menu"), and select <7> to enter the
Boot ROM operation menu.
Step 2: Select <2> in the Boot ROM operation menu to upgrade the extended segment
of Boot ROM program through XModem. The security gateway provides several speed
options. The subsequent operation steps are the same as those described in section
5.2 I. "Upgrading the application program".
Note:
This upgrade approach is used to upgrade only a portion of the Boot ROM program, so
you may make a second attempt once an error occurs.
Chapter 5 Software Maintenance
5-5
I.