Table of Contents
Advertisement
Installation Manual
H3C SecPath V100-S Security Gateway
Stop bits = 1
Flow control = none
Figure 4-4 Setting communication parameters
Step 6: Click <OK>. The HyperTerminal dialog box appears.
Step 7: Select Properties.
Step 8: In the [Properties] dialog box, select the [Settings] tab, as shown in Figure 4-5.
Figure 4-5 Setting the terminal type
Chapter 4 Booting and Configuring the SecPath V100-S
4-3
Advertisement
Table of Contents
Need help?
Do you have a question about the SecPath V100-S and is the answer not in the manual?