Table of Contents
Advertisement
8
9
-
4. INSTALLATION
Place the machine on the support surface, lifting it up only from underneath.
Adjust the feet so that the machine fits perfectly in a horizontal position and tilting slightly backwards.
Before connecting the machine to the supply systems, ensure that the data on the nameplates correspond with the ratings where the
machine is installed.
4.1 ELECTRIC INSTALLATION DIAGRAM
Take note of all warnings and advice in this manual when carrying out
the electrical connection.
Furthermore, the power supply cable must be completely uncoiled to
avoid dangerous overheating.
Check the voltage in the place of installation of the machine and
then connect the power supply cable as shown in the figure below.
The cables of the machine are marked in the following way:
A - Power supply cable of the machine;
B - Motor pump cable (when not incorporated in the machine).
a) Connect cable (A) directly to the single pole switch (1).
b) Connect cable (B) directly to the motor pump (2).
Versions of the machine with the motor pump incorporated do not
have the cable (B).
Attention!
Connect the yellow/green conductor lead of cable (B) to the earth terminal on the motor pump (when the motor pump is not
incorporated in the machine).
18
B
1
A
2
Fig. 11
espresso coffee machines
Legend:
1 Main switch (prepared
by the customer);
2 Motor pump (if not
built in).
LSI 089 - Rev. 00 - Ed. 04/2015
Hide quick links:
Advertisement
Table of Contents
