Table of Contents
Advertisement
•
The appliance has class I protection against electric shocks.
•
The noise emitted by the appliance during normal operation is less than 70 dB .
•
The maximum altitude at which the machine may be installed is 8000 meters .
•
Children shall not play with the appliance.
•
Cleaning and use maintenance shall not be made by children without supervision.
•
These instructions are also available in an alternative format, e.g. on a website.
Attention!
!
Failure to comply with the above regulations could jeopardise the correct operation and safety of the appliance as well as its useful lifetime.
INSTALLATION REQUIREMENTS FOR THE USER
surface height for the appliance of no less than 1.2 metres from
the ground. Check this important requirement, since the manu-
facturer cannot be considered liable for any damage caused by
the instability of the appliance. While preparing the systems, take
into account that a hole is needed on the bearing surface in order
to carry out all electric and water connections through the open -
ing below where a water softener will need to be placed, if recom-
mended by the installation engineer.
A hole of 10 x 10 cm is enough in the area (a) as indicated in Pict.
The minimum size of the opening below is:
- height
cm. 60
- width
cm. 40
- depth
cm. 40
EN LSC 050 06-2020
Y
X
2
3
1
Legend:
1 Multi-pole power
switch with a switch-
contact gap of
at least 3 mm.
2 Water supply tap
3 Drain siphon
X
X min. 20 cm.
Y min. 40 cm.
Z* min. 10 cm.
*) distance
between the back
of the appliance and
the wall.
V
Advertisement
Table of Contents
