Table of Contents
Advertisement
espresso coffee machines
5.3 GROUP DOSE SETTING – EK MODEL
Hold down the free flow button
flash (the dose symbols stay lit) and all the symbols on the other touchpads switch off.
Within 30 seconds fasten a filter holder (18) containing a dose of ground coffee to the group; put a cup below the filter holder and press
the button "1 short coffee" (m) on the corresponding touchpad. The symbol for the selected dose will remain lit to indicate that the dose
is being set. The symbol flashes while all others are switched off.
When the coffee reaches the required dose, press the button "1 short coffee" (m) again to stop the coffee delivery and confirm the re-
quired dose. When the dose has been set, the relevant symbol will switch off to show that programming is complete.
Repeat this operation for the other buttons (n-p-q), also on the touchpad on the right.
Take note!
Carry out this procedure to program the remaining doses, using the 1-cup filter holder (18) or the 2-cup one (7), according to
the type of dose to be programmed.
Take note!
To quit the programming function, press the free flow delivery button (o) for 5 seconds or, alternatively, wait 1 minute to quit
the function automatically.
Danger!
By setting the doses on the first touchpad on the right, automatically the other groups will be acquiring the same doses; if
you want to set a group with different doses, repeat the same dose setting procedure on the touchpad corresponding to the
group you want to program differently.
LSI 089 - Rev. 00 - Ed. 04/2015
on the first touchpad from the right (1st GROUP) for about 5 seconds, until the symbol begins to
8
9
-
45
Hide quick links:
Advertisement
Table of Contents
