Table of Contents
Advertisement
Attention!
Failure to comply with the above regulations could jeopardise the correct operation and safety of the appliance as well as its
useful lifetime.
Warning!
The appliance is supplied without a plug. It is supposed to be directly connected to the electric mains and therefore, it is
necessary to fit a single-pole switch with contact opening of 3 mm or more beforehand, according to the regulations in force .
2.2 INSTALLATION REQUIREMENTS FOR THE USER
The machine has to be placed on a stable flat surface that can
guarantee a safe position. Check this important requirement,
since the manufacturer cannot be considered liable for any dam-
age caused by the instability of the appliance. While preparing
the systems, take into account that a hole is needed in the bear-
ing surface in order to make all electric and water connections
through the opening below where a water softener will need to be
fitted, if recommended by the installation engineer.
A hole of 10 x 10 cm is enough in the area (a) as indicated in
Pict. 6.
The machine needs a minimum clearance of:
- height
cm. 60
- width
cm. 40
- depth
cm. 40
12
Y
X
X
A
2
1
3
Fig. 6
espresso coffee machines
Legend:
1 Single pole switch
with an opening of at
least 3 mm between
contacts
2 Water supply tap
3 Drain siphon
X min. 20 cm.
Y min. 40 cm.
Z* min. 10 cm.
*) Distance between the
back of the appliance
and the wall.
LSC 040 - Rev. 00 - Ed. 12/2009
Hide quick links:
Advertisement
Table of Contents
