Table of Contents
Advertisement
espresso coffee machines
3. Push the preset hot water delivery infusions button (3), the symbols flashes to show that you're programming the mixing.
4. When the dose is on the desired quantity, push again the button (3) to end the mixing.
When programming the mixed hot water function, to exit from the programming push the free-flow delivery button
seconds or wait for about 1 minute for the automatic exit.
Take note!
The MIXED HOT WATER FUNCTION for infusions required a specific hydraulic circuit.
For further information about this system, contact La Spaziale SpA.
5.11 AUTOMATIC MILK FOAMING SYSTEM WITH ADJUSTABLE TEMPERATURE - M.A.T. - (optional)
After the correct temperature setting process and the air suction adjustment, this system can be used for automatic milk foaming.
To program the set temperature, proceed as follows:
1. Switch off the appliance.
2. Press and hold down together the buttons
the main switch.
3. Only the previously set value for the temperature will remain lit on the control panel.
4. To change the setting, press the buttons
5. To quit the programming function and store the new setting, switch the appliance off and then on again, using the main switch (12).
Take note!
The temperature value on the control panel must be converted back using the conversion table here below:
t
°C
55
56
57
105
107
106
LSI 089 - Rev. 00 - Ed. 04/2015
(i) and
(i) and
59 60 61 62
58
63 64
111
112
113
108
109
110
(g), on the programming touchpad and switch on the appliance using
(g).
65 66
67 68
69 70
114
115
116
117
118
119
8
-
71 72
73 74 75
120
121
122
123
124
125
9
(o) for about 5
29
Hide quick links:
Advertisement
Table of Contents
