Initial Installation Before Connecting Power - La Spaziale S1 Vivaldi II Owner's Manual

S1 Vivaldi II Owner's Manual
There is a switch labeled ON / OFF on top of the controller box adjacent to the 15A/20A
switch shown in the above photo. (The ON/OFF switch is hidden in the photo.) This switch
must be set to OFF if you do not have the Timer plugged in and it must be set to ON when
the timer is installed. Also, the state of this switch is only sensed when the power cable is
unplugged, then plugged back in. So if you need to change this switch you will need to
unplug the machine for at least 5 seconds after you do so.
WARNING: If you do NOT have the Timer installed but you have the switch set to ON, the
pump will not come on when you try to pull a shot.

4.3 Initial Installation Before Connecting Power

After removing the VII from its packing carton and setting it on the counter, check for
additional installation instructions that may be included. You should also have all the
accessories shown in the photo below including a rubber backflush disk (not shown).
Tip the VII on its side. Twist all four rubber feet (3) hand tight as they may vibrate loose
during shipping. While performing that task, use a screwdriver to ensure that the four screws
on the bottom (two on each side between the rubber feet) which fasten the two side panels
(5) to the chassis bottom are tight. These steps will help ensure the quietest possible
operation of your VII.
Be sure you connect the included water hose to the threaded water inlet on the bottom of the
machine. Proper connection is obvious since there is only one place it can attach. The
opposite end of the hose - which connects to the water supply - may require adapters from
your local hardware store depending on your specific situation. Contact your VII dealer for
advice if the solution isn't obvious. Also, your VII dealer may request that you check that your
water hardness is below a certain level to ensure long life and trouble free operation.
Page 8