Attaching The Round Hole Adapter Kit To The Rails (Optional) - Cisco UCS 5108 Installation Manual

Attaching the Round Hole Adapter Kit to the Rails (Optional)

Step 3
Verify that all unused blade slots and power supply bays have blank covers.
Attaching the Round Hole Adapter Kit to the Rails (Optional)
Note The chassis tool-less rails are designed for racks that have square mounting holes. You must use the round
hole adapters (N20-CRMK2-RHA=) to install the chassis in racks that have round mounting holes.
This round hole adapter kit allows you to adapt the rail kit (N20-CRMK2=) to install into rack (front and/or
rear) posts that use either threaded or non-threaded round holes. Four adapters in the kit are for adapting the
rail kit to install into rack posts with threaded round holes, and the other four adapters in the kit are for adapting
the rail kit to install into rack posts with non-threaded round holes. You can use a combination of adapters
based on the type of holes in the rack posts. Various sizes and lengths of screws are also included in the kit.
Procedure
Step 1 Insert the adapter tab into the mounting rail as shown in callout 1.
Step 2
Slide the adapter up to lock it into position as shown in callout 2.
Step 3 Secure the adapter into place using the provided pan-head screw as shown in callout 3.
Cisco UCS 5108 Server Chassis Installation Guide
32
Installation