Installing and Removing Components
Figure 41: Positioning a PDU (N01-UAC1) in the Cisco UCS Server Chassis, AC Version
Step 2
Push the PDU module into the chassis until it seats properly. If power supplies are installed, you may need
to partially remove them.
Step 3
Tighten the captive screws.
Step 4
If necessary, reseat the power supplies and restart the system to observe LED behavior.
Removing a PDU
Procedure
Step 1
Partially remove all installed power supplies. If a power supply is seated into the PDU, removal is difficult
or impossible.
Step 2
Loosen the captive screws.
Step 3
Pull the PDU clear of the chassis by pulling on the captive screws. Support its weight from below.
Cisco UCS 5108 Server Chassis Installation Guide
Removing a PDU
67