Repacking The Chassis; Sfp+ Transceivers; Sfp+ Twinax Copper Transceivers; Sfp+ 10 Gb Ethernet Transceiver - Cisco UCS 5108 Installation Manual

Installation
Step 2
Disconnect the power cords and networking cables from the chassis.
Step 3 Remove all modules and blades from the chassis to lighten its weight.
Step 4
Remove the screws holding the front rack-mount flange to the rack.
Step 5 With two people holding the chassis, make sure that its weight is fully supported.
Step 6 Gently slide the chassis off the rails, and out of the rack.
Step 7
Replace the modules and blades in the server chassis.

Repacking the Chassis

If you need to repack the chassis, remove it from the rack by reversing the steps in the
from a Rack, on page 52
and container to pack the chassis. Replacement packaging can be ordered using the following PIDS:
• If you have only half-width blades, use UCSB-5108-PKG-HW=.
• If you have full-width blades or a mix of full-width and half-width blades, use UCSB-PKG-FW=.
If you are returning the chassis to Cisco, contact your Cisco customer service representative to arrange for
return shipment to Cisco.

SFP+ Transceivers

Each FEX within the chassis supports Small Form-Factor Pluggable (SFP+) copper or optical transceivers.
Each transceiver runs at 10 Gb.

SFP+ Twinax Copper Transceivers

The FEX also supports Twinax copper transceivers. The enhanced SFP+ 10-Gb Ethernet transceiver is a
bidirectional device with a transmitter and receiver in the same physical package. It has a 20-pin connector
on the electrical interface.
Table 11: SFP+ 10 Gb Ethernet Transceiver
Model
SFP-H10GB-CU1M
SFP-H10GB-CU3M
SFP-H10GB-CU5M
SFP-H10GB-ACU7M
SFP-H10GB-ACU10M
The figure below shows the SFP-H10GB-CU5M transceiver. The rubber loop is used for removing the SFP+
from its port on the I/O module.
section, and then pack it for shipment. If possible, use the original packing materials
Cisco UCS 5108 Server Chassis Installation Guide
Description
10-Gb Ethernet—copper SFP+ (1 m, 3.28 ft.)
10-Gb Ethernet—copper SFP+ (3 m, 9.84 ft.)
10-Gb Ethernet—copper SFP+ (5 m, 16.4 ft.)
10-Gb Ethernet—copper SFP+ (7 m, 22.9 ft.)
10-Gb Ethernet—copper SFP+ (10 m, 32.8 ft.)
Repacking the Chassis
Removing the Chassis
53