Connecting An Optical Fiber To A Fiber Port - H3C MSR3610-X1 Installation Manual

Figure 20 Connecting the device to a terminal

Connecting an optical fiber to a fiber port

WARNING!
Do not stare into any fiber port when you connect an optical fiber. The laser light emitted from the
optical fiber might hurt your eyes.
Follow these guidelines when you connect a fiber cable:
•
Never bend or curve a fiber when connecting it.
•
Make sure the Tx and Rx ports are connected correctly.
•
Keep the fiber end clean.
•
Be sure to install the dust cover if the fiber port is not connected to a fiber connector.
To connect an optical fiber:
Remove the dust plug from the fiber port.
1.
Align the transceiver module end without a pull latch to the fiber port. Correctly orient the
2.
transceiver module and insert it into the fiber port.
Identify the Rx and Tx ports on the transceiver module. Use the optical fiber to connect the Rx
3.
port of the transceiver module to the Tx port of the peer device and the Tx port to the Rx port.
Examine the port LED on the device to verify that the optical fiber is connected correctly. For
4.
more information, see "Appendix B LEDs."
Figure 21 Connecting an optical fiber to a fiber port
1 2
18
3