Install Rear Panels - Avaya S8700 Installing Manual

Install Rear Panels

Install the rear panels and loosely thread each screw. See
1
on page 99.
For un-stacked media gateways, tighten the screws securely.
2
For a stack of media gateways, allow the screws labeled callout 4 to remain loose. These
screws are tightened when the ground plates are installed.
Be sure the Time Division Multiplexing (TDM) bus cables and the Inter-Cabinet Cables
3
(ICC) are not pinched by the panels. Also be sure the cables are routed through the
channels provided on the rear panels.
Rear Panel Screw Locations
Figure notes
Expansion Control Media Gateway A (No ground plate is installed on an un-stacked
1
media gateway)
Rear Ground Plate (attached between stacked media gateways)
2
Port Media Gateway B
3
Screws to Loosen
4
1
May 2002
Installing the S8700 Multi-Connect
Installing an Avaya SCC1 Media Gateway Stack
''Rear Panel Screw Locations''
4
2
3
4
grnd_plt CJL 030696
99