Verify Date And Time; Connect Duplication Cables; Configure Media Server 2 - Avaya S8700 Installing Manual

Verify date and time

The following administration is done on the services laptop computer connected to media server
1 using the S8700 Media Server Web Interface.
Click Set Server Time/Timezone to view the current time, date, and time zone settings.
1
If the time is within 3 minutes of the correct time, do nothing.
If it is not, then set the current time to the correct minute and click Submit.
2
Unplug the laptop from media server 1.
3

Connect duplication cables

Connect the crossover CAT5 cable and fiber optic cable between the media servers. Refer to
Getting Started with Avaya S8700 Media Server for Multi-Connect
installation information.for a connectivity guide.

Configure Media Server 2

The following administration is done on the services laptop computer connected to server 2
using the S8700 Media Server Web Interface.
NOTE:
Make sure you have the complete list of IP addresses and host names before starting this
process.
NOTE:
Make sure your networking and Web browser settings are correct. Refer to
Pre-Installation Information—S8700
1 Plug server 2 into UPS 2 to power it up. Refer to
Media Server for Multi-Connect Configuration.
2 Connect the laptop to the dedicated services port on server 2 (usually port 2 (Eth1)).
3 Click Start > Run to open the Run dialog box.
Type command and press
4
Type arp -d 192.11.13.6 and press
5
will respond with one of the following:
The command line prompt when the cache has been cleared.
•
The phrase: The specified entry was not found. This is returned when the
•
specified IP address does not currently contain an entry in the ARP cache.
Launch the Web browser.
6
Type 192.11.13.6 in the Location (Netscape) or Address (Internet Explorer) field to bring
7
up the Web interface.
Multi-Connect.
Getting Started with Avaya S8700
to open a MSDOS Command Line window.
Enter
to clear ARP cache in the laptop. This command
Enter
May 2002
Installing the S8700 Multi-Connect
Configure the Hardware in the Rack
Configuration. for
29