Position The Auxiliary Cabinet (Optional); Install Auxiliary Cabinet Equipment; Install Earthquake Protection For Media Gateway - Avaya S8700 Installing Manual

46 Installing the S8700 Multi-Connect
Installing an Avaya MCC1 Media Gateway

Position the Auxiliary Cabinet (Optional)

1
2
3

Install Auxiliary Cabinet Equipment

The auxiliary cabinet allows for carrier, 23-in. (58.4 cm) rack, or panel mounting of the
hardware. The following equipment is furnished with the media gateway:
•
•
•
•
Install equipment inside the media gateway as specified in the CSD. The following optional
equipment can be installed:
•
•
•
•
•

Install Earthquake Protection for Media Gateway

Use the correct procedure for your installation:
•
•
Position the auxiliary cabinet next to the control hardware in the rack (or a media
gateway). The location of equipment inside the auxiliary cabinet is specified in the
Customer Service Document (CSD).
If earthquake protection is required, refer to
Gateway'' on page 46.
If earthquake protection is not required, level the auxiliary cabinet and adjust and lock its
stabilizing bolts to keep it from moving.
—
Fuse panel Distributes -48 VDC power to fused cabinet circuits
—
Power receptacle strip
—
DC connector block
DC source
AC to DC power supply
switched outlet to the required DC voltage.
909A/B Universal Coupler
—
Fan Assembly Requires 120 VAC power
External Channel Service Unit (CSU)
PagePac Paging System
power.
External system announcement units -- may be powered by either -48V DC or 120 VAC.
''Install Concrete Floor Mounting'' on page 47
''Install Raised Computer Floor Mounting'' on page 47
''Install Earthquake Protection for Media
Provides switched and un-switched 120 VAC receptacles
Required when the auxiliary cabinet is powered by an external
—
Converts AC power provided by the AC power strip
—
1 is required for each T1 carrier link
—
3 models are available. All PagePac models require 120 VAC
May 2002