Add Media Gateways; Administer And Enable Ipsi(S) - Avaya S8700 Installing Manual

38 Installing the S8700 Multi-Connect
Configure the Hardware in the Rack

Add Media Gateways

NOTE:
Do this procedure only if the translations were not input earlier.
The following administration is done on a computer used to access the Avaya S8700 Media
Server using Avaya Site Administration.
1
2

Administer and Enable IPSI(s)

!
CAUTION:
The following procedure must be executed on all configurations. This includes
configurations that are translated using a bulk provisioning tool such as Avaya Site
Administration or ProVision. When Avaya MultiVantage™ software is first initialized it
does not know the primary and secondary control subnet addresses. Submitting the
following form will cause the Avaya MultiVantage™ software to read this information
from the media server and update itself correctly.
1
change system-parameters ipserver-interface
SERVER INFORMATION
OPTIONS
2
Type add cabinet number (2 through 44) and press
Gateway.
Fill in the equipped carrier types for the Media Gateway.
Type change system-parameters ipserver-interface and press
IP SERVER INTERFACE (IPSI) SYSTEM PARAMETERS
IPSI Host Name Prefix: vodka
Primary Control Subnet Address: 198.152.254.
Secondary Control Subnet Address: 198.152.255.
Switch Identifier: A
IPSI Control of Port Networks: disabled
Verify that the Primary and Secondary (if equipped) Subnet Addresses are correct. The
subnet in these fields should match the most significant 3 octets of the Server IP address
on control network entry from the Pre-Installation Network Worksheet. If there is an
Asterisk (*) to the right of the Subnet Address fields it means that the Avaya
MultiVantage call processing software does not contain the subnet information
displayed. After verifying the displayed information, submitting this form will cause the
Avaya MultiVantage software to be updated with the subnet information displayed.
May 2002
for each equipped Media
Enter
.
Enter
Page 1 of
0 *
0 *
1