Configure Media Server 1 - Avaya S8700 Installing Manual

Configure Media Server 1

This section covers the following tasks:
• ''Copy license and Avaya authentication files from laptop to Media Server 1'' on page
25
''Install license and Avaya authentication files'' on page 25
•
The following administration is done on the services laptop computer connected to server 1
using the Web-based administration application.
NOTE:
Make sure you have the complete list of IP addresses and names before starting this
process.
NOTE:
Make sure your networking and Web browser settings are correct. Refer to
Pre-Installation Information—S8700
Plug server1 into UPS 1 to power it up. Refer to
1
Server for Multi-Connect
On the laptop Click Start > Run to open the Run dialog box.
2
Type command and press
3
Type arp -d 192.11.13.6 and press
4
command will respond with one of the following:
The command line prompt when the cache has been cleared.
•
The phrase: The specified entry was not found. This is returned when the specified IP
•
address does not currently contain an entry in the MAC cache.
Launch the Web browser.
5
6 Type 192.11.13.6 in the Location (Netscape) or Address (Internet Explorer) field to bring
up the Web interface.
Multi-Connect.
Getting Started with Avaya S8700 Media
Configuration.
to open a MSDOS Command Line window.
Enter
to clear MAC cache in the laptop. This
Enter
May 2002
Installing the S8700 Multi-Connect
Configure the Hardware in the Rack
21