Frequency Converter HiD2891
5.3
Operating and display elements
The following operating and display elements are located on the front
side of the device:
•
LED FAULT (red) for display
− a line failure at the input
(terminals 1 to 7; flashes red)
− of the simulation mode (flashes red)
− a device failure (continuously red)
•
LED STATUS (yellow) to indicate the output status
•
LED RELAY (yellow) to indicate the relay status
•
LED PWR ON (green) to indicate the presence of the supply voltage
•
Serial RS 232 interface for connection to a PC for programming and
diagnosis of the device using PACTware
You will find the following control elements on the device side (see also
section 6.1):
•
DIP switch SW1 for setting the input type
•
DIP switch SW2 for setting the output type
14
TM
PWR
ON
FAULT STATUS
RELAY
2891