Frequency Converter HiD2891
Mounting the device on the termination board:
Please ensure that the red Quick Lok Bar (1) is in the upper position.
Center the pins over the contacts on the termination board. Observe the plug
orientation of the device.
Carefully press the device into the contacts.
Press the red Quick Lok Bar (1) down on either side of the device (see figure)
The device is mounted.
5. 2 Connecting the device
The device is connected by means of the terminals of the termination board, which permits a fast and
faultfree exchange in case of failure.
The terminals are self-opening and have a spacious connecting area for a core cross-section of up to
2.5 mm².
10
(1) Quick Lok Bar
1