Network Menu - Notifications Menu - Epson EV-110 User Manual

Projector Network Settings - Network Menu
Network > Network Configuration > Wired LAN
s
Setting Options
IP Settings DHCP
IP Address
Subnet Mask
Gateway Address
IP Address Display On
Off
IPv6 Settings
Description
Set DHCP to On if your network assigns
addresses automatically; set to Off to
manually enter the network's IP
Address, Subnet Mask, and Gateway
Address using 0 to 255 for each address
field.
Do not use these addresses: 0.0.0.0,
127.x.x.x, 192.0.2.x or 224.0.0.0 through
255.255.255.255 (where x is a number
from 0 to 255) for IP Address,
255.255.255.255 or 0.0.0.0 through
254.255.255.255 for Subnet Mask, and
0.0.0.0, 127.x.x.x or 224.0.0.0 through
255.255.255.255 for Gateway Address.
Select whether to display the IP address
on the LAN standby screen.
Select the IPv6 settings if you want to
connect the projector to the network
using IPv6:
Setting Options
IPv6
Auto Configuration Set to On to assign addresses
Use Temporary
Address

Network Menu - Notifications Menu

Settings on the Notifications menu let you receive an email notification if a
problem or warning occurs in the projector.
Network > Network Configuration > Notifications
s
134
Description
Set to On if you want to connect the
projector to the network using IPv6.
IPv6 is supported to monitor and control
the projector over a network using Epson
Web Control and PJLink.
automatically according to the Router
Advertisement.
Set to On if you want to use a temporary
IPv6 address.