Table of Contents
Advertisement
5.4.4 Modifying or Reviewing a Device
To Modify or Review the device parameters proceed as follows:
Step 1
Select "MODIFY
[1]
DEVICES" Option
02:ZONES DEVICES
MODIFY SENSORS
– Modifying or Reviewing a Device
Enter the Installer Menu, select the "02:ZONES/DEVICES" option (see section 5.2) and then select the "MODIFY
[1]
DEVICES" option.
Select the respective group of the device you wish to review or modify. For example, "MOTION SENSORS".
[2]
[3]
Scroll the Device Group, identify (by zone and/or ID number) of the exact device you wish to modify or review, for
example: "Z10:Motion Camra > ID No. 140-1737".
[4]
From here on the process is same as the configuration process that follows the enrollment of that device. To
continue, refer to Section 5.4.2 "Adding a New Wireless Device" Part B. When done, the display will show the
next device of the same type (i.e. "Motion camera").
5.4.5 Replacing a Device
Use this option to replace a faulty device that is enrolled in the system with another device of the same type number
(i.e. same first 3 digit of the ID number – see section 5.4.2.A) while keeping the same configuration of the original
device. There is no need to delete the faulty device or to reconfigure the new device. Once enrolled, the new device will
be configured automatically to the same configuration of the faulty (replaced) device.
To Replace, a device proceed as follows:
Step 1
Select "REPLACE
[1]
DEVICES" Option
02:ZONES/DEVICES
REPLACE DEVICES
– Replacing a Device
[1]
Enter the Installer Menu, select the "02:ZONES/DEVICES" option (see section 5.2) and then select the
"REPLACE DEVICES" option.
[2]
Select the respective group of the device you wish to replace. For example, "KEYFOBS".
[3]
Scroll the Device Group, identify (by zone and/or ID number) the exact device you wish to replace, for example:
"K03: Keyfob > ID No. 300-0307".
If you try enrolling a new device of a different type than the replaced device, the WP8010/WP8030 will reject the
new device and the display will read "WRONG DEV.TYPE".
When done, the display shows the device details of the new device.
D-306233 CUSDOC PM-10/30 V18 DSC TRIPLE EN INST
Step 2
Select the respective
[2]
device Group
CONTACT SENSORS
MOTION SENSORS
Step 2
Select the respective
[2]
device Group
CONTACT SENSORS
KEYFOBS
Step 3
Select exact device
[3]
you wish to modify
Z10:Motion Camra
ID No. 140-1737
Step 3
Select exact device
[3]
you wish to replace
K03:Keyfob
ID No. 300-0307
3. WP8010 INSTALLATION
Step 4
Select the Parameter
[4]
you wish to modify
Z10:LOCATION
Z10:ZONE TYPE
Z10:SET CHIME
Z10:PARTITIONS
Z10:DEV SETTINGS
Step 4
Enroll the new device
[4]
ENROLL NOW or
ENTR ID:300-XXXX
Step 5
Modify the
Parameter
See [4]
When
done to
step 2
Step 5
See
[4].
37
Advertisement
Table of Contents
