Table of Contents
Advertisement
3. WP8010 INSTALLATION
3.3 System Planning & Programming
Program the system now as instructed in the programming section.
The tables in APPENDIX C will help you plan and record location of each detector, the holder and assignment of each
transmitter.
3.4 GSM Module Installation
The internal GSM 350 module enables the WP8010system to operate over a GSM/GPRS cellular network (for further
details, see the GSM 350 PG2 Installation Instructions).
The GSM modem auto detection feature enables automatic enrollment of the GSM modem into the WP8010 control
panel memory. GSM modem auto detection is activated in one of two ways: after tamper restore and after reset
(power-up or after exiting the installer menu). This causes the WP8010 to automatically scan GSM COM ports for the
presence of the GSM modem.
In the event that the GSM modem auto detection fails and the modem was previously enrolled in the WP8010G2
control panel, the message "Cel Remvd Cnfrm" will be displayed. This message will disappear from the display only
after the user presses the
message will be displayed.
Note:
A message is displayed only when the WP8010alarm system is disarmed.
Plug in the GSM module and fasten it as shown in the
above drawing.
A. GSM
B. Front unit
Caution! Disconnect both batteries and AC power before
installing or removing the GSM module or SIM card.
Figure 3.4 – Optional GSM Module Mounting and SIM Card Insertion
10
button. The modem is then considered as not enrolled and no GSM trouble
Insert the SIM card into the GSM module as shown in the
above drawing.
1. Slide top cover.
2. Open cover
3. Align SIM card in cover (note cover orientation)
4. Slide SIM card into cover
5. Rotate cover to close
6. Lock cover to close
IMPORTANT! Do not insert or remove SIM card when the
control panel is powered by AC power or battery.
D-306233 CUSDOC PM-10/30 V18 DSC TRIPLE EN INST
Advertisement
Table of Contents
