Table of Contents
Advertisement
3. WP8010 INSTALLATION
Part B - Configuration
Step 1
Enter Location Menu
➯
Z10:LOCATION
Step 5
Enter Chime Menu
➯
Z10:SET CHIME
Step 9
Enter Device Settings
Menu
➯
Z10:DEV SETTINGS
- Configuring New Devices
Location (name) setting:
[1]
To review or change the Location (name) setting, press the
[2]
To change the Location name, enter the menu and select the name from the "Location List" below. You can
assign additional custom names using the "06.CUSTOM NAMES" option in the Installer menu. See section 5.8.
Note: As a shortcut, press the 2 digit serial No. of the Custom Location, which takes you directly to its menu.
Zone Type setting:
[3]
To review or change the Zone Type setting, press the
[4]
The zone type determines how the system handles signals sent from the device. Press
suitable zone type. The list of available Zone Types and the explanation for each zone type is provided below.
Note: As a shortcut, press the 2 digit serial No. of the Zone Type shown in the Location List below, which takes
you directly to its menu.
Chime setting:
All zones are set to chime OFF by default. To configure the device to cause the panel to sound (when disarmed) a
[5]
Chime melody when tripped, press the
Note: For UL Listed Product, the Chime setting must be set to "Chime ON".
Select between "Chime OFF", "melody-chime" and "zone name-chime"
[6]
panel sounds a chime melody when the sensor is tripped. In "zone name-chime" the control panel sounds the
zone name when the sensor is tripped. The chime operates during the Disarm mode only.
Partitions setting:
Note: The "PARTITIONS" menu appears only if Partitions is enabled in the control panel (see section 5.13).
When entering the menu, the display shows the default Partition selection (marked with ).
[7]
[8]
Use the keypad keys
Device Configuration:
[9]
To review or change the Device Configuration (settings), press the
option – see [11].
[10]
To configure the device parameters, refer to its corresponding device datasheet in the device Installation
Instructions. The defaults of the device parameters can be also configured as explained in section 5.4.7.
1
Refers to WP8030 only
34
Step 2
[1]
Select Location
(see list below)
Dining room
Custom 5
Step 6
[5]
Select Chime option
chime OFF
melody-chime
Step 10
[9]
Configure Device
Parameters
Refer to device
datasheet in the device
Installation Instructions
for specific configuration
instructions.
,
,
Step 3
Enter Zone Type
[2]
➯
Z10:ZONE TYPE
Step 7
[6]
Enter Partitions Menu
➯
Z10:PARTITIONS
Step 11
[10]
Continue or End
To continue –
See [11]
button, otherwise scroll to the next option.
button, otherwise scroll to the next option.
button, otherwise scroll to the next option.
to assign partitions to the device.
D-306233 CUSDOC PM-10/30 V18 DSC TRIPLE EN INST
Step 4
[3]
Select Zone Type
(see list below)
1:Exit/Entry1
5. Interior
Step 8
[7]
Select Partition options
Z10:P1
P2 P3
and select a
1
. In "melody chime" the control
button, otherwise scroll to the next
[4]
[8]
Advertisement
Table of Contents
