Table of Contents
Advertisement
3. WP8010 INSTALLATION
5.2.1 Entering the "Installer Mode" if "User Permit" is enabled
In certain countries the regulations may require user permission to make changes in the configuration of the panel. To
comply with these regulations, the "Installer Mode" option can be accesses only via the "User Settings" menu. The
Master user must first enter the "User Settings" menu then scroll until the "Installer Mode" option is shown and then
the installer can continue as shown in the above table (see also
To configure the panel to comply with user permission requirements - see option #91 "User Permit" in section 5.5.8.
5.2.2 Selecting options
– Selecting an option from a menu
Example: To Select an Option from the "COMMUNICATION" menu:
[1]
Enter the Installer Menu and select the "04.COMMUNICATION" option (see section 5.2).
[2]
Select the sub-menu option you need, for example: "3: C.S. REPORTING".
[3]
Select the parameter you wish to configure for example: "11:RCVR 1 ACCOUNT"
[4]
To continue, go to the section of the selected sub-menu option, for example section 5.6.4 for the
"3:C.S.REPORTING" menu, and look for the sub-menu you wish to configure (e.g. "11:RCVR 1 ACCOUNT"). After
configuring the selected parameter the display returns to step 3.
To Change the Configuration of the Selected Option:
When entering the selected option, the display shows the default (or the previously selected) setting marked with .
To change the configuration, scroll
confirm. When done, the display reverts to Step 3.
5.2.3 Exiting the Installer Mode
To exit the Installer Mode, proceed as follows:
Step 1
[1]
Any screen
– Exiting the Installer Mode
To exit "INSTALLER MODE", move up the menu by pressing the
[1]
reads "<OK> TO EXIT" or preferably; press the
screen "<OK> TO EXIT".
When the display reads "<OK> TO EXIT", press
[2]
The system exits the "INSTALLER MODE" menu and returns to the normal disarm state while showing the
[3]
READY display.
5.3 Setting Installer Codes
The WP8010/WP8030 system provides two installer permission levels with separate installer codes, as follows:
Master Installer: The "Master Installer" is authorized to access all Installer Menu and sub-menu options. The
default code is: 9999 (*).
Installer: The "Installer" is authorized to access most but not all Installer Menu and sub-menu options. The default
code is 8888 (*).
Guard Code: Enables an authorized guard to only Arm Away / Disarm the control panel. The default code is 0000 (*).
The following actions can be performed only by using the Master Installer code:
Changing the Master Installer code.
Defining specific communication parameters – see "3:C.S REPORTING" in sections 5.6.1 and 5.6.4.
Resetting the WP8010/WP8030 parameters to the default parameters – see "09:FACTORY DEFLT" in section
5.11.
Note: Not every system includes a Master Installer code feature. In such systems, the Installer can access all Installer
Menu and sub-menu options the same as a Master Installer.
(*) You are expected to use the default codes only once for gaining initial access, and replace it with a secret
code known only to yourself.
30
the "Options" menu and select the setting you wish and press
Step 2
<OK> TO EXIT
or
[1] in Step 1 above).
Step 3
[2]
[3]
READY 12:00
button repeatedly until the display
button once which brings you immediately to the exit
.
D-306233 CUSDOC PM-10/30 V18 DSC TRIPLE EN INST
to
Advertisement
Table of Contents
