Table of Contents
Advertisement
Table 6. Stand-alone gateway installation checklist (continued)
Task
Description
U
Section 4: Power-up all components
4–1
Turn on the breaker(s) to power the PDUs.
h
4–2
Power-up the disk expansion module(s).
h
Power-up the disk controller.
4–3
h
4–4
Power-up the server.
h
4–5
Power-up the TSSC, display panel, and TSSC
h
Ethernet switch
Section 5: Perform post-installation validation checks
5–1
Check power indicators for all components.
h
5–2
Validate Ethernet link-up indicators on the
h
TSSC.
Validate Ethernet link-up indicators on the
5–3
h
customer's local area network (LAN) to the
server and the TSSC.
5–4
Validate fibre channel link-up indicators from
h
the disk controller to the server.
| | |
|
5–5
Validate fibre channel (VTL) or Ethernet (OST)
h
|
|
link-up indicators from the customer host to
|
the server.
Section 6: Prepare the TSSC for use with the TS7650G
6–1
Configure the TSSC's communication settings.
h
Section 7: Perform RAS package configuration and verification
7–1
Configure the RAS package on the server.
h
7–2
Perform RAS verification. Includes verifying
h
attached systems and testing Call Home.
Section 8: SSR releases the system to trained ProtecTIER specialist or LBS representative
|
| | |
8–1
Configure ProtecTIER, including configuring
h
|
|
OST if applicable, and create the file system.
8–2
Install the ProtecTIER Replication Manager
h
application, if applicable.
8–3
Install ProtecTIER Manager and create the
h
repository.
8–4
Turn the system over to the customer. If
h
replication is being used, advise the customer
that it is their responsibility to create and
configure the replication grid.
Where to find information
N/A
"Disk expansion modules" on page 70.
"Disk controllers" on page 70.
"Servers" on page 70.
"TSSC and KVM kit" on page 71.
"Visually inspecting indicator and fault LEDs"
on page 71.
"Visually inspecting indicator and fault LEDs"
on page 71.
"Visually inspecting indicator and fault LEDs"
on page 71.
"Visually inspecting indicator and fault LEDs"
on page 71.
"Visually inspecting indicator and fault LEDs"
on page 71.
"Setting up the TSSC for use with the
TS7650G" on page 77.
Chapter 6, "Configuring the RAS package," on
page 83.
Chapter 7, "RAS verification," on page 91.
Chapter 8, "Configuring ProtecTIER using
ptconfig," on page 95.
Chapter 9, "Enabling the ProtecTIER
Replication Manager," on page 111.
Chapter 10, "Installing ProtecTIER Manager,"
on page 113.
N/A
Chapter 4. Installing the TS7650G hardware
25
Advertisement
Table of Contents
