Table of Contents
Advertisement
|
|
|
|
|
|
|
|
|
|
|
|
128
IBM System Storage TS7600 with ProtecTIER: Installation Roadmap Guide
Services stopped
Checking conditions...
Checking BOM [ Done ]
Checking for existing nodes [ Done ]
Checking NICs for Replication [ Done ]
Checking repository [ Done ]
Checking conditions done
The following message displays. In the message, the term "remote node" refers
to Server A.
In order to continue, the GFS and VTFD services on the remote node must
be stopped. Are the GFS and VTFD services stopped on the remote node?
(yes/no)
11. Type: yes <enter>.
12. You are then prompted, one at a time, to enter the values listed below for
Node B. After typing each value, press <enter>:
Important: Values set during manufacturing display in [brackets]. If you are
enabling replication, you will need to change all of the default values to reflect
the customer's specific configuration. If you are not enabling replication, you will
need to change the defaults except when prompted for Replication Port
information. In this case, press <enter> without entering a value.
v Customer Network, IP address [192.168.167.162]:
v Customer Network, Netmask [255.255.255.0]:
v Customer Network, Default Gateway [168.159.150.9]:
v Customer Network, Hostname [node2]:
(This is the name provided by the customer to identify this server on their
local network. The hostname should be free of extensions or .com suffixes.
For example: cougar9000)
v Replication Port 1, IP Address [192.168.170.1]: (eth3)
v Replication Port 1, Netmask [255.255.255.0]:
v Replication Port 1, Hostname [replicationNode1_1]:
(for example: jaguar_source_1)
v Replication Port 2, IP Address [192.168.171.1]: (eth4)
v Replication Port 2, Netmask [255.255.255.0]:
v Replication Port 2, Hostname [replicationNode1_2]:
(for example: jaguar_source_2)
The system automatically starts the network configuration process and a series
of status messages display.
13. When a message displays indicating that configuration is complete, proceed as
appropriate:
v If you are enabling replication, continue to step 14.
v If you are not enabling replication, go to step 21 on page 132.
14. When you have returned to the command prompt, define the static routes
used for replication. Enter the command:
./ptconfig -staticRoutes <enter>
The message below displays:
Gathering System information [ Done ]
The auto-detected system information displays. For example:
Advertisement
Table of Contents
