Table of Contents
Advertisement
Table 19. Clustered 1 Gb Ethernet switch Ethernet connections for OpenStorage configuration (continued)
Callout
From
18
Port 4, slot 4
|
|
|
|
|
|
|
|
|
|
|
|
56
IBM System Storage TS7600 with ProtecTIER: Installation Roadmap Guide
On Device
Server B
Procedure
1. Label and connect Ethernet cables (Cat 5e or higher) according to Figure 22 on
page 55 and Table 19 on page 55.
2. Go to "Clustered Ethernet connections" on page 52 to complete the Ethernet
cabling.
Clustered TSSC and customer network Ethernet connections
This task describes the TSSC and customer network Ethernet connections for
theTS7650G server in a clustered configuration.
Before you begin
Notes:
v Depending upon the model of the TSSC and TSSC network switch being used,
the port layout may differ from what is shown in the following figures. If so,
make the cable connections according to the port number assignments specified
in the associated tables, regardless of the position of the ports on the switch.
Refer to the IBM System Storage TS3000 System Console (TSSC) Maintenance
Information for detailed port information.
v Connection of the replication network cables is required only if the customer is
enabling the data replication feature.
Clustered TSSC, KVM and customer network Ethernet connections for VTL
configuration:
This task describes the TSSC, KVM and customer network Ethernet connections for
theTS7650G server in a clustered configuration with VTL.
About this task
Note:
Depending upon the model of the TSSC and TSSC network switch being used, the
port layout may differ from what is shown in Figure 23 on page 57. If so, label the
cables according to the port number assignments specified in Table 20 on page 57,
regardless of the position of the ports on the TSSC or the switch.
To
Customer's replication
network
On Device/Location
Customer specified device
Advertisement
Table of Contents
