Table of Contents
Advertisement
| |
| | | |
|
|
| |
|
|
|
|
|
|
|
|
|
130
IBM System Storage TS7600 with ProtecTIER: Installation Roadmap Guide
Available Options:
==================
(a)dd a new record
(e)dit a record
(d)elete a record
(c)ommit changes
(q)uit
Please Choose (a,e,d,c,q):
17. Type: a <enter>.
You are prompted for the information for the second destination (target - eth5
for VTL, eth11 for OpenStorage) server and the local network.
Attention: Do not configure the replication ports Eth2 and Eth5 (VTL) or
Eth7 and Eth11 (OpenStorage) on the same subnet as the external LAN port
Eth0. Doing so may cause replication errors.
18. At each prompt, type the requested information and then press<enter>:
Please provide the following information:
Target Network Address:
(starting network address) (for example: 10.11.196.0)
Target Network Netmask:
(for example: 255.255.255.0)
Local Gateway Address:
(the gateway IP address of the server you are currently configuring) (for
example: 10.11.197.0)
An updated summary displays:
Table 45. Example updated summary of both servers and local networks
Target Network
ID
Address
1
10.11.194.0
2
10.11.196.0
Important: The addresses in the summary are examples. In this instance the
term target refers to the network address of the nodes at site 1 and site 2.
Actual values will vary.
For reference, write the actual values from the summary screen in the blank
spaces below.
Depending on your replication configuration, the "remote node" Target
Network Address may be the same network starting address for Server A and
B if more than one node is replicating to a single node.
Table 46. Site 1 – Server A worksheet
Site 1 – Server A
ID
Target
Network Address
(Remote node's
starting network
address)
Local Gateway
Target Netmask
Address
255.255.255.0
10.11.195.1
255.255.255.0
10.11.197.1
Target Netmask
Local Gateway
Address
(Remote node's
netmask)
(The gateway address
for Server A at Site 1)
Advertisement
Table of Contents
