Table of Contents
Advertisement
Installing the 1 Gb Ethernet switches
|
|
|
Figure 9. WTI network power switch
Also refer to Figure 2 on page 12 for the recommended location of the WTI
network power switch in the server frame.
2. When physical installation is complete, go to "Installing the 1 Gb Ethernet
switches."
Use this procedure to install the 1 Gb Ethernet switches.
About this task
IBM best practices recommends installing the 1 Gb Ethernet switches near the
middle of the clustered gateway server frame. See Figure 2 on page 12.
When performing the installation, use caution to avoid dislodging or damaging the
cabling within the frame.
Procedure
1. Attach the mounting brackets and power cords to the Ethernet switches. To do
so:
Chapter 4. Installing the TS7650G hardware
33
Advertisement
Table of Contents
