Table of Contents
Advertisement
|
|
| |
Table 11. Customer and replication Ethernet connections for stand-alone OpenStorage configuration
| | | | |
Callout
From
1
| | | | |
Port 1, slot 5
15
|
| | | |
Port 4, slot 3
|
16
|
| | | |
Port 4, slot 4
|
|
40
IBM System Storage TS7600 with ProtecTIER: Installation Roadmap Guide
Procedure
1. Label and connect Ethernet cables (Cat 5e or higher) according to Table 9 on
page 39 and Table 10 on page 39.
Notes:
v Depending upon the model of the TSSC and TSSC network switch being
used, the port layout may differ from what is shown in Figure 13 on page 39.
If so, make the cable connections according to the port number assignments
specified in Table 10 on page 39, regardless of the position of the ports on the
TSSC or the switch. Refer to the IBM System Storage TS3000 System Console
(TSSC) Maintenance Information for detailed port information.
v Connection of the replication network cables is required only if the customer
is enabling the data replication feature.
2. Go to "Stand-alone fibre channel connections" on page 42.
Ethernet connections for stand-alone OpenStorage configuration
The tasks in this section describe the network Ethernet connections used with
theTS7650G server in a stand-alone configuration for OpenStorage.
About this task
Figure 14. Customer and replication Ethernet connections for stand-alone OpenStorage
configuration
On Device
Server A
Server A
Server A
To
On Device/Location
Customer Network
Customer specified device
Customer's replication
Customer specified device
network
Customer's replication
Customer specified device
network
Advertisement
Table of Contents
