Table of Contents
Advertisement
| |
Table 13. Customer host network Ethernet connections for stand-alone OpenStorage configuration
| | | | |
Callout
From
1
| | | | |
Port 1, slot 3
2
| | | | |
Port 2, slot 3
3
| | | | |
Port 3, slot 3
4
| | | | |
Port 1, slot 4
5
| | | | |
Port 2, slot 4
6
| | | | |
Port 3, slot 4
|
Stand-alone fibre channel connections
|
|
42
IBM System Storage TS7600 with ProtecTIER: Installation Roadmap Guide
Figure 16. Customer host network Ethernet connections for stand-alone OpenStorage
configuration
On Device
Server A
Server A
Server A
Server A
Server A
Server A
Procedure
1. Label and connect Ethernet cables (Cat 5e or higher) according to Table 11 on
page 40, Table 12 on page 41 and Table 13.
Notes:
v Depending upon the model of the TSSC and TSSC network switch being
used, the port layout may differ from what is shown in Figure 15 on page 41.
If so, make the cable connections according to the port number assignments
specified in Table 12 on page 41, regardless of the position of the ports on the
TSSC or the switch. Refer to the IBM System Storage TS3000 System Console
(TSSC) Maintenance Information for detailed port information.
v Connection of the replication network cables is required only if the customer
is enabling the data replication feature.
2. Go to "Stand-alone fibre channel connections."
The tasks in this section describe the fibre channel connections for theTS7650G
server in a stand-alone configuration.
About this task
Important:
To
On Device/Location
Designated device
Customer's host network
Designated device
Customer's host network
Designated device
Customer's host network
Designated device
Customer's host network
Designated device
Customer's host network
Designated device
Customer's host network
Advertisement
Table of Contents
