Table of Contents
Advertisement
98
IBM System Storage TS7600 with ProtecTIER: Installation Roadmap Guide
Stopping Cluster Services [ Done ]
Services stopped
Checking conditions...
Checking BOM [ Done ]
Checking for existing nodes [ Done ]
Checking NICs for Replication [ Done ]
Checking repository [ Done ]
Checking conditions done
3. You are prompted, one at a time, to enter the values listed below. After typing
each value, press <enter>.
Important: Values set during manufacturing display in [brackets]. If you are
enabling replication, you will need to change all of the default values to reflect
the customer's specific configuration. If you are not enabling replication, you will
need to change the defaults except when prompted for Replication Port
information. In this case, press <enter> without entering a value.
v Customer Network, IP address [192.168.167.161]:
v Customer Network, Netmask [255.255.255.0]:
v Customer Network, Default Gateway
v Customer Network, Hostname [node1]:
(This is the name provided by the customer to identify this server on their
local network. The hostname should be free of extensions or .com suffixes.
For example: cougar9000.)
v Replication Port 1, IP Address [192.168.170.1]: (eth2)
v Replication Port 1, Netmask [255.255.255.0]:
v Replication Port 1, Hostname [replicationNode1_1]:
(for example: jaguar_source_1) (The replication hostname used by ProtecTIER
Replication Manager.)
v Replication Port 2, IP Address [192.168.171.1]: (eth5)
v Replication Port 2, Netmask [255.255.255.0]:
v Replication Port 2, Hostname [replicationNode1_2]:
(for example: jaguar_source_2) (The replication hostname used by ProtecTIER
Replication Manager.)
The system automatically starts the network configuration process. The
following status messages display:
Configuring network [ Done ]
Configuring Replication Network [ Done ]
Restarting Network Service [ Done ]
Stopping cluster [Done]
Configuring cluster [Done]
Starting cluster [ Done ]
Installing NTP [ Done ]
Starting VTFD Service [ Done ]
Validation will start in 10 seconds
Testing connectivity to the Default Gateway [ Done ]
Getting number of nodes [ Done ]
This is a 1 node cluster, will not test fencing
Validation ended
Advertisement
Table of Contents
