Automatic Daily Transmitter Signal Check - Primex XR Series Install Manual

Automatic Daily Transmitter Signal Check

At six pre-scheduled times a day, at 2 am/pm, 10am/pm, and 6 am/pm clock time (not actual time), a clock's receiver
automatically turns on and begins searching for the Transmitter signal, starting with the previously stored channel number. If a
signal is not received from the first channel, the clock scan all channels to search for a signal.
Reset clock time - to reset the time after the initial set up procedure, simply remove the batteries. The clock is then ready to go
through the initial set up procedure.
Loss of time signal - if the clock has not received a time signal for three days, the second hand enters a double step mode. Low
batteries can cause this non-signal reception - should this occur, replace the batteries.
19