Replace Batteries - Primex XR Series Install Manual

Replace Batteries

How you replace the batteries for a Manual Setting Analog Clock is dependent on its current battery power. A manual setting
clock has both a button and a grey set wheel on its backside.
If the clock currently has battery power, perform the steps below in section
l
operating
.
If the clock does not have battery power, perform the steps below in the section
l
Setting Clock that is not operating (no battery power)
How to replace batteries for a clock that is operating
A manual setting model has both a button and a grey set wheel on the back of the clock.
1. Remove the clock from its location to access the back of the clock.
2. Press the button located on the back of the clock. The system clock beeps three times, records the hand position in memory,
and stops its hand movement.
3. Remove the old batteries.
4. Insert two new alkaline batteries. It's important that fresh, superior-quality batteries with an expiration date that exceeds five
years past the current year. Be sure to insert the batteries with the battery "+" end to the "+" end of the battery holder.
5. When both batteries are in place, the clock beeps three times and set its hands to the correct time. For the next minute the
clock continues to beep with every valid decoded signal.
If the batteries are replaced quickly the clock may not triple beep or start when the batteries are inserted. If this happens, press
l
the button and you should hear the triple beep and the clock will start.
If the clock is in a good signal area it beeps every second. If the clock is in a marginal signal area, it beeps every few seconds.
l
If the batteries have been removed for over 1 hour and 15 minutes, the clock double-steps until the next scheduled time
l
update and will then set the hands to the correct time.
How to replace batteries for a Manual Setting Clock that is not operating (no battery power)
If a Manual Setting Analog Clock is not operating, these specific battery replacement steps are required to be completed.
1. Remove the clock from its location to access the back of the clock. Do NOT press the button before removing batteries.
2. Remove the batteries.
NOTE
The clock should not beep when the batteries are removed.
20
How to replace batteries for a clock that is
How to replace batteries for a Manual
.
XR Analog Clock Install Guide