Install Analog Clock; Installation Requirements - Primex XR Series Install Manual

Install Analog Clock

Installation Requirements

Refer to the Important Safety Instructions before installing, operating or performing maintenance of clocks.
l
Before installing a clock, verify the system Transmitter is operating properly and sending a signal with adequate building
l
coverage
Broadcast (Transmit) Schedule Transmitter with Internal Antenna: broadcasts its synchronized time continuously to the system
clocks and devices.
Broadcast (Transmit) Schedule Transmitter with External Antenna: broadcasts its synchronized time to the system clocks and
devices from the 39th to the 6th minute of the next hour and changes to a standby mode during the 7th to the 38th minute of
the hour (standard broadcast schedule). During initial power-up, the Transmitter broadcasts for 8 consecutive hours. After the
8 hour power-up period, the Transmitter reverts to its timed broadcast schedule. Power cycling the Transmitter also initiates an
8 hour continuous broadcast.
Clocks must be installed at a location within adequate transmission range of the Transmitter.
l
Manual Setting Analog Clock Models - verify its set up procedure is completed before the clock is installed.
l
Any damage to the clock due to improper wiring voids the warranty. It is at Primex discretion as to whether damage to the
l
clock was caused by improper wiring.
WARNING
Battery-powered models only: For sites with multiple Transmitters or repeaters, do not install clock batteries until the
clocks are located at their permanent installation location.
22
XR Analog Clock Install Guide