Core Rear Upper Connectors - Omron LD-250 User Manual

6.2 Payload Bay Connections - LD-250 Core
RS232 1 and 2
The LD-250 Core's RS232 1 and 2 DB9M connector provides two ports for use with peripheral
devices such as the HAPS sensors (See: High-Accuracy Positioning System (HAPS) on page 190.)
If not used for other devices, you can also use the ports for port forwarding information from
other RS232 devices. See the SetNetGo chapter in the Fleet Operations Workspace Core User's
Guide.
LD-250 Core Rear Upper Connectors
Figure 6-4 shows the connectors on the LD-250 Core's upper rear interface panel. Some if these
connectors are available for customer use.
Table 6-3 describes the connector type and typical use of the connector.
100
Pin No. Designation
1, 4, 6, 9 No Connection
2 RS232_USR#_RXD #=1 or 2
3 RS232_USR#_TXD #=1 or 2
5 GND
7 RS232_USR#_RTS
8 RS232_USR#_CTS
Figure 6-4 LD-250 Core Rear Upper Interface Panel
LD-250 Platform User's Guide
Notes
#=1 or 2
#=1 or 2
20472-000 Rev B